Proper Gutter And Drip Edge Installation

Lay the gutter into the brackets that you ve lag screwed to the fascia.

Proper gutter and drip edge installation.

If it doesn t pull the drip edge out slightly from under the shingles. Use a flat pry bar and hammer to pry the nails out of the drip edge gently. There was no way that the gutter installe was going to get the upper edge of the gutter behind the drip edge. It can be done.

Rotate the gutter upward until its back edge slips into the hooks at the top of the back of the brackets as shown. For proper water drainage the drip edge on the rakes should always overlap the drip edge on the eaves. Gently lift up the shingles on the edge of the roof and locate the nails holding the existing drip edge onto. The best practice is to always install the drip edge so that it is inside the gutter.

It is put under the shingles of an attic to flow water directly into the gutter. Some rain runoff by capillary action runs up under the shingle drip edge and down the fascia behind the gutter installing drip edge on a new roof or re roofing job. How to install a drip edge. The whole purpose is to direct the water into the gutters.

A gutter apron is installed on the corners above roof decking. A gutter apron is used where shingles are not far enough from the edge of the gutter. Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated. Make sure the outer edge extends over the gutter.

Rain gutter installation can be a tricky job and a lot of. There are two reasons for water getting behind the gutter. The roofer installed the drip edge tight against the fascia. Secure the drip edge with roofing cement.

One of the reasons is that your shingles may be too short. This works out correctly if you do the eaves first. While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter. Once free slide the drip edge out and discard.