Radon Fan In The Basement Or Attic

The purpose of a radon fan is to draw radon from out of the soil below the home and release it safety above the house.

Radon fan in the basement or attic.

In cold environments this condensation can freeze and effect the life of the radon vent fan. Electrical components are out of reach. I have never found a radon fan more than a bit warm even if the motor has been stalled by some blockage so there appears to be no concern about causing a fire from. Radon fans and electrical components are out.

The air flowing through the fan will maintain the fan temperature. If you have a radon level of around 4pci l the level of radon being pushed out of the exhaust side of the fan can be many times higher even into the 100s. All radon mitigation installation standards require that the radon fan be located outside the living space of the home. They will need to access all areas of the basement along with the garage and attic areas.

The radonaway rp145c radon fan is built to resist moisture and can be mounted inside or outside on a 3 in. Make a hole. Instead of having the fan and venting pipes on the outside of the home the only visible component on the outside is the vent stack that rises through the roof. When a radon system is installed in the attic space the fan and all electrical components are also located in the.

You will need to place the fan such that it is outside the living area of your house. Fans placed in attics garages and outside locations will keep you safe. Radon fans inside attic spaces are better protected from the freeze and thaw cycle. In the attic the pipe runs to an in line fan that runs.

Related how to test for radon and get rid of it. This is required of a radon mitigation system as it protects you from a leak at the site of the fan which would result in a pooling of radon as the fan pulls radon up but then fails to expel it from. Radon fan location why is the basement not a proper radon fan location. Beyond a certain level the epa recommends a fan powered suction system to evacuate radon from the house.

The reasoning for this is that if a leak was to occur above the fan your house could have a really high radon level. If the radon fan is located in the attic of the house or garage you can wrap the fan with fiberglass insulation. The location of the radon fan. This radon fan is designed for moderate to good air flow working most effectively with sub slab or sub material conditions ranging from about 4 in.

Of clean size 4 6 gravel to very loose soil. Many homeowners with a finished basement are concerned about the radon mitigation process. In the attic in the garage or outside least preferred. The radon system is hidden.

Or closet and then run the pipe along the exterior of the home with the fan placed right up against the outside of the home. Radon fans are better protected from the elements.